△ Photo 22-25 图片22-25

这些圆形通风口是通过蓝丁胶假组的，好处就是他没粘牢，涂完底色后。我们可以方便地把他拿下来喷涂浅灰色。有时我也会用AV的哑光保护漆来一层，确保所有漆面的光泽度统一。

总结一下吧，首先我还是强烈建议在喷涂之前把模型用洗洁精和温水好好清洗一下。另外，尽可能的对一些需要后续单独上色或旧化的零件假组，方便取下，从而可以获得更好的效果，也能在后续旧化过程中节省很多时间。此外，大家也看到除了喷涂单一的底色之外，我们还笔涂的细节，从而在一些部分获得了对比。接下来来看看怎么喷涂迷彩和相关的注意事项吧。

These round vents are one example as to theadvantage of temporarily attaching components by means of Blu-Tak instead ofgluing them permanently. After airbrushing the basecoat I was able to removethis piece and quickly airbrush the light grey tone representing the zincphosphate primer. A few coats of Vallejo matt were used to finish the flatbase-coat insuring that the brush painted acrylics and primer red surfaces had aunified matt texture.

I strongly recommend that you always cleaneverything with dish washing detergent and warm water prior to airbrushing. Tryto keep as many components and sub-assemblies removable from the model aspossible. This will let you easily position the parts allowing for betterresults while also permitting you to save time during painting and weatheringas you will see. You can also see that a basecoat can consist of a few stepsaside from airbrushing such as brush painting details to get some contrastamongst parts. A few nice coats of matt varnish, in this case, also whereapplied. Let’s now move on to airbrushing a camouflage and some things toremember while doing so.

编辑君：本期翻译稿略长，我们分两期发送，给大家一些消化的时间哈~

文 / Adam Wilder

译 / facewest